My project using TDA4 VH + SDK 8.6 before. Secure boot is normal. Now I want to using SDK9.1.The chip has already burned the keywriter. Because sdk8.6 and sdk9.1 use the same keywriter version, So we ...

I am working on a project using the Xilinx (AMD) ZCU216 development kit with the CLK104 add-on card. The CLK104 board uses the LMK04828. I am providing a 10MHz reference signal to the LMK chip using ...

I am using the LP-CC2652RB Launchpad to develop a BLE device. I am using CCS 12.8.0.00012 with Simplelink SDK 7.41.0.17 and SysConfig 1.18.1. I am using TI-RTOS7 for the RTOS. When I try to open up ...

I got stuck at using TI's "Solar_CLA.h". We have successfully initialized CLA and ran simple task which was perfectly working. In the next step, I followed the steps provided in the Solar Library ...

We are trying to verify the behavior of a supply-bootstrapped circuit using OPA828 in a TINA simulations. The purpose of the circuit is to reduce the common mode input impedance. However, we can see ...

I don't see the option to select the option of flashing the chip address in the Promgramming Mode of the EEPROM in the GUI of the EVM, may I know how to use this tool to flash the chip address?Thank ...

The compiler version is TI v20.2.7.LTS. After outputting the .out file to a .bin file, when I burn the .bin file to the chip using UniFlash, the firmware does not work properly. Start analyzing the ...

I'm going to use AWR1642EVM with DCA1000 to get the MIMO raw data, and generate a virtual antenna array. (as figure 5) (FIGURE BELOW IS FROM TI DOCUMENT.) I know that there are two TX and four RX on ...

As stated in the safety manual, the junction temperature could be measured on ADCB. But the controller has only ADCA and ADCC so is there another way to measure the temperature of the device?

we are working on a project where we are using a debugger and we are not sure about the 10 pin connection of ...

The schematic diagram we designed, how to submit the application, ask TI's experts to help review it, Please kingly guide the submission path ...

I have used the part DS90UB954-Q1 De-Serializer in my board and with DS90UB953-Q1 Combinations in Camera Module. One of my board iam facing video streaming issue ,MIPI output is not coming from the ...