设置SPI多个片选引脚除了config里面定义的其余引脚是否需要用GPIO虚拟，同时虚拟出来的引脚对传输速率是否有影响 可以使用GPIO模拟，在每次SPI发送之前，对SPI的片选信号也会进行控制，所以SPI ...

I am trying to implement state machine based tasks in 28027. I referred some programmes given in control suite. I am however not able to go between various tasks A0, A1, A2 etc. What could be the ...

Understanding these aspects is crucial for our project and system stability. Any insights or additional documentation you could provide would be highly valuable. Thank you for your assistance.

Customer run into below MMC init error in SDK 10_00_00_08, while they didn't find this error in SDK 09_02_00_05 and they can enter into kernel successfully. Could you ...

My customer is using MSP-GANG as programming tool for LP-MSPM0G3507. they faced the issue when programming, see the status below. But they are able to program MCU with XDS110, so the MCU works well.

I am currently experiencing an issue with the OTP Keywriter (PSDK RTOS J721S2 08.04. + OTP_KEYWRITER_ADD_ON_j721s2_08_04_00_02): OTP Keywriter Version: 02.00.00.00 (Nov 21 2024 - 09:45:21) OTP ...

Texas Instruments (TI) Isolation support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search isolation IC content or ask ...

My flashed code works fine on the first build but does not load after CPU reset or power cycle. Upon CPU reset, the code is initially stuck at 0x3fdba4 with the following warning statement: Break at ...

I'm using TMDSCNCD263 evaluation board and Gpio interrupt example from SDA, thats working fine, Now more interrupt have to configure on GPIO14, GPIO29, GPIO55 and GPIO78, Sysconfig tool used to ...

Texas Instruments (TI) Interface support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search interface IC content or ask ...

Minimum possible value of the input signal frequency is 5 MHz according to SNAS646C. Table 1 shows boundaires for input path components. The problem: if I want to use input frequency 5 MHz (for ...

In this project, there is a main.syscfg, it generate a file buck_settings.h, inside this file, it include a file buck_user_settings.h, but i changed the latter file ...