This is due to the internal 100k pull-up resistors that cannot be disabled within the IO expander. This is why there is a difference between HIGH and LOW inputs. LOW inputs will cause current to flow ...

We used CCS Theia 1.3.1 command line for automatically building projects. Now we update the CCS Theia to 1.5.1. But we find that build command will not return error ...

I have some question s on the fueses. this is not only relates to TPS2HCS10-Q1, but in generakl for the HCS -Family. I have following questions: Standby - Active Mode of MCU eFuses must be active even ...

2)VIO pin required & supply voltage level is 3.3v 3)Should have CAN Signal improvement capability as per CiA-601-4 standard I am seeing the potential of TCAN1042-Q1. Will this work with the ...

I have an industrial project where there will be one master controller connected to six (6) slave controllers. The physical location of the plant is such that it would be very much feasible for me to ...

Vin: I created a circuit that boots from 5V to 6.3V and converts it to 5V with a regulator, but when I connect a 100mA load, Vout drops to 5.3V. Can you catch a waveform of the unexpected Vout drop.

i bought for my private study a launchxl-f28379D and launchxl-f280049C , i've never had an experience with that mcu's before . I'm using a CCS version 12.6.0.00008 on Win11 . I had a problem with ...

We have encountered a boot up issue with TDA4AL at -40 degree C. The boot up process hanged and cannot be recovered even we try to reset the PMIC power on process. The boot process kept the same ...

I am configuring a new laptop with TI development tools, using the same products as on an older computer. The older computer has been running CCS version 12.4 and C2000ware version 5.02.00.00 for over ...

We are seeking assistance with a Flyback SMPS design using the UCC28750 controller. The design was based on the UCC28750EVM-071 User Guide and the UCC28750 Datasheet. At no load, the output reaches a ...

1. Based on suggestion from this LM5190-Q1: CC-CV regulator design - Power management forum - Power management - TI E2E support forums , will this LM5177 Buck-Boost Controller work well for my ...

I am trying to implement state machine based tasks in 28027. I referred some programmes given in control suite. I am however not able to go between various tasks A0, A1, A2 etc. What could be the ...